Surface treatment:
It is possible to apply CeboArt Stucco on substrates such as gypsum plaster, lime or cement based fine renders. Ensure that the substrates are perfectly clean and dry, with uniform aspect and absorption.

CeboFix R:
Pigmented, breathable fixative, containing fine quartz sands. Apply one coat of CeboFix R with a short hair woollen roller. In case of rough or irregular substrates apply CeboFondo smooth render, when CeboFix R is completely dry.

CeboArt Stucco
Refined polished plaster for interiors, based on lime putty that grants a natural and excellent water vapour permeability and resistance to moulds and bacteria.
With CeboArt Stucco the real effect of ancient Stucco Veneziano can be easily obtained, to achieve elegant and timeless decorations.

CeboArt Stucco application cycle
Apply CeboArt Stucco in three coats with a stainless steel trowel. On the prepared and dry surface apply a sufficient quantity of product to attain a smooth layer. When the first coat is completely dry (after about 6-8 hours) apply the second coat with a stainless steel trowel or blade to create the desired decoration, then smooth the surface perfectly. In the third coat apply a small quantity of product, slightly softened, removing the excess; before the product dries completely, polish the entire surface with the same trowel.

CeboArt Marmorino
Mineral wall coating for interiors that allows to achieve highly valuable decorations, attaining the smooth satin and slightly dotted surface of the classical marmorino finishes.

CeboArt Marmorino application cycle
Apply one coat of CeboArt Marmorino with stainless steel trowel, to the properly prepared wall; on the perfectly dry substrate apply the second coat and compact the product.

EcoCera:
Water based, natural wax for interiors based on beeswax and Marseille soap to increase the natural brightness of the surfaces, giving at the same time water repellence. Carefully mix the product. Should it appear too dense, dilute with 5% of
warm water. Apply EcoCera only when CeboArt Stucco o Marmorino is completely dry. Use a synthetic sponge avoiding excess of product; polish the surface with a woollen cloth within 30-40 minutes.

CeboWax
Interior finishing based on natural bee wax and selected binders; it allows to create soft shades, leaving the surface breathable and hydrophobic. CeboWax
can be diluted with water until a maximum of 30%; it must be applied with synthetic sponge in one or two coloured coats, from bottom to top on a completely dry surface. Note: it is recommended to mix the product during use.

CeboSil
Breathable and water-repellent acrylic-siloxane protective finish with a matt and velvety touch. Dilute the product with water in a 1: 1 ratio. CeboSil is applied in one hand with a synthetic sponge, proceeding from the bottom upwards to avoid dripping.