Surface preparation:
Gypsum, lime and cement surfaces are suitable but have to be clean, dry and uniform in aspect and absorption.

CeboFix R:
Pigmented and breathable primer, contains quartz powder. Can be applied with a short hair roller in one or two coats till the complete cover of the surface. On dry CeboFix R, on irregular surfaces, apply CeboFondo.

CeboArt Model
Materic coating for internal suitable for the creation of both classic and modern effects.

Applications of CeboArt Model:

Spatolato effect:
Apply the product with the stainless steel trowel in an homogeneous thickness and then create the effect by a crossing and irregularly movement of the trowel. Before complete drying, flatten slightly the most irregular parts; if the product would be too much dry, wet the trowel.

Sbrecciato effect:
Apply the product with the stainless steel trowel with a thickness of 1,5-2 mm. Draw the product still wet with CeboSign; to obtain a natural effect, proceed irregularly, avoiding repetitions in the draw. Before complete drying, flatten slightly the most irregular parts; if the product would be too much dry, wet the trowel.

Onda effect:
Apply the product with the special Onda trowel, in a uniform thickness of 1.5-2 mm, vertically or horizontally depending on of the required effect: working on the surface with the shaped side of the Onda trowel, following the direction of processing. Before complete drying, flatten slightly the most irregular parts; if the product would be too much dry, wet the trowel.

A fine finish for indoor use, created with whitewash and natural waxes. CeboArt Lux adds value to the surfaces finished in CeboArt Model, enhancing the deepness of the pattern and giving extra brilliance and a peculiar bleached look.

How To Apply CeboArt Lux On CeboArt Model:
Apply a first coat of colored CeboArt Lux over CeboArt Model, when it is perfectly dry and free from dust, using a stainless-steel trowel and making sure to follow the pattern created previously with the tool strokes. When the outer layer of the finish is dry (after about 3-4 hours), apply a second coat. It is advisable to apply each coat in a single thin layer. Later, when the wall starts to dries, crape it with a clean stainless-steel trowel to give it a final polishing.

EcoCera:
A natural water-based wax for indoor use created with the white beeswax and Marseille soap, which makes it water-repellent and enhances the natural brilliance of the surfaces. Stir the compound well before use: if it looks to dense, dilute it with 5% of warm water. You should only apply EcoCera when CeboArt Lux is completely dry. Spread the finish with a synthetic sponge, trying not to scoop excessive quantities; after 30-40 minutes polish it by hand using a wool cloth.