Preparing the surfaces
CeboFix R:
Water based, acrylic, pigmented fixative containing fine quartz sands. Carefully clean the substrate and apply one coat of product with a short hair woollen roller.

Note: if the surface is too crumbly, or if needs to be partially renewed, first use CeboFix M to prepare it.

Application cycle for smooth CONCRETE (CEMENTO Domino):
Use a stainless steel trowel to spread a first layer of CeboArt Pozzolano, tinted as shown in the folder, making long vertical strokes and being careful not to make them all at the same height. When the first coating has dried, put a second one, using the same method; it is adviseable to start the two layers at a different height, so that the unpleasantly looking junction line is not seen. Before the surface gets completely dry, pass a clean trowell all over it, to make it more compact and smooth. If the product is too dry, you can wet the trowel with water. Wait until CeboArt Pozzolano is completely dry, then put a finishing touch using CeboTech.

Application cycle for formwork CONCRETE (CEMENTO Casserato):
Use a stainless steel trowel to spread an even layer of CeboArt Pozzolano, tinted as shown in the folder, using vertical or horizontal strokes, depending on the desired effect. While the product is still humid, work the surface in bands about 1 m wide, using the “false wood” tool (art. A/29) to imitate the nervation imprint left by the casing. Before the product gets completely dry, smooth it out with a clean trowel, flattening slightly the salient patches. If the product is too dry, you can wet the trowel with water. When the first coating of CeboArt Pozzolano is completely dry, apply a second one only in the chosen areas, marking their limits with masking tape and creating a relief pattern. Wait until CeboArt Pozzolano is completely dry, then put a finishing touch using CeboTech.

Application cycle for Domino CONCRETE (CEMENTO Domino):
Use a stainless steel trowel to cover the whole surface with a first layer of CeboArt Pozzolano, tinted as shown in the folder, making long strokes in the chosen direction (vertical or horizontal) and being careful not to make them all at the same height. When the first layer has dried, divide the wall into checks, using a 9 mm wide ribbon and pasting stickers about 4 cm large at the angles of the checks; then proceed to apply a second layer using the same method. Before the surface gets completely dry, pass a clean trowell all over it, to make it more compact and smooth. If the product is too dry, you can wet the trowel with water. Wait until CeboArt Pozzolano is completely dry, then put a finishing touch using CeboTech.

CeboTech:
Water based, protective coating, based on acrylic micro-emulsion. Colour the product in the chosen shade and dilute 1:4 with water. CeboTech must be applied in one coat with a synthetic sponge, following the design previously created. Apply the product from bottom to top to avoid dripping.