Preparing the surfaces:

Warning: make sure that the surfaces are uniform, completely clean and dry. In case of recent trowelling, fresh brickwork, crumbling or absorbing surfaces, first use a brush to apply a coating of CeboFix M fixative sealant, diluted with water 1:1.

CeboFix R: coloured water-based acrylic fixative containing quartz powder. Apply one coat of the product, using a short pile roller.

OXYDIA

Application system
Apply one coat of CeboStone (colour 254/2), using a medium size flat brush: spread the product with vertical strokes on stripes about 50 cm wide, then use the “narrow side” of the brush over the painted surface to accentuate the pattern. Before the surface dries completely, smooth in with the special gray plastic pointed trowel; use downward strokes, pressing it slightly against the wall to level any lumps. When CeboStone is completely dry, apply CeboIron in two colours, as indicated in the reference table.

CeboIron: apply the first CeboIron colour with a synthetic sponge, following the direction of the strokes, until you have covered the basecoat. Wait until the first layer dries (4-6 hours), then apply the second colour, following the same direction: stroke the surface with the sponge so that the underlying colour shows. It is advisable, while applying the second colour, to keep the first one at hand, so that you can easily repair eventual mistakes.

DESIGN

Apply the first coat of CeboArt Model (colour 254/M), levelling and smoothing the surface with a stainless steel trowel; when the surface is dry, place the stencil to the wall with some masking tape and apply a second coat of CeboArt Model, making strokes from the edges of the stencil to its centre and making sure to keep its rear side clean. Afterwards, place another stencil and continue as described before, repeating the action as many times as necessary. It is advisable to remove the stencils while the product is still humid, while any resulting defect may be removed when the surface is dry.

CeboIron: the featured effect is based on the use of two colours of CeboIron, as indicated in the reference table. Apply the first CeboIron colour with a synthetic sponge, until you have covered the basecoat. Wait until the first layer dries (4-6 hours), then apply the second colour, stroking the surface with the sponge so that the underlying tint shows. It is advisable, while applying the second colour, to keep the first one at hand, so that you can easily repair eventual mistakes.

LAMINA

Preparing the surfaces
Warning: make sure that the surfaces are uniform, perfectly level, clean and dry. In case of recent trowelling, fresh brickwork, crumbling or absorbing surfaces, apply a coat of CeboFix M fixative by paintbrush, diluted with water 1:1.

Application system
CeboFix R: apply by roller one or two coats of CeboFix R (colour 254/2), diluted with 20-30% of water.

CeboIron: the featured effect is based on the use of two colours of CeboIron, as indicated in the reference table. Use a paintbrush to apply the first CeboIron colour in vertical stripes, that will be subsequently smoothed with the gray plastic pointed trowel. It is advisable in this phase to alternate the coated stripes with free spaces, which will be covered and treated using the second CeboIron colour, to be applied in the aforementioned manner after the first one dries (4-6 hours). It is advisable, while applying the second colour, to keep the first one at hand, so that you can easily repair eventual mistakes.